For switching and dimming incandescent lamps, HV halogen lamps and LV halogen lamps using dimmable wound transformers or electronic transformers. (Phase control and phase alignment) With integral bus coupler, screw terminals, short-circuit, open-circuit and excess temperature protection with soft start function. For installation onto DIN rails EN 50022. \n \nThe dimming actuator automatically recognises the connected load. Combinations of ohmic and inductive, or ohmic and capacitive loads can also be connected. Combinations of inductive and capacitive loads must not be connected. Bus connection is via bus terminals; a data rail is not necessary. \n

FEATURES

\n- Dimming operation via KNX \n- Extension units and on the device \n- Different dimming curves and dimming speeds \n- The same dimming time \n- Memory function, ON/OFF delay \n- Staircase time function with/without manual OFF function \n- Scenes (up to eight stored brightness values can be retrieved) \n- Central function \n- Logic operation or priority control \n- Blocking function \n- Status feedback \n

TECHNICAL DETAILS

\n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n

BUS type:	KNX
total number of 18 mm modules:	6
Mounting support:	DIN rail
[Ue] Rated operational voltage:	220...230 V @ 50/60 Hz
Number of outputs:	4
Load type:	LV halogen lamps : 50...150 VA (wound transformer) \nIncandescent lamps : 30...150 W, 230 V AC \nHalogen lamps : 30...150 W, 230 V AC \nLV halogen lamps : 50...150 W (electronic transformer)
IP degree of protection:	IP20

\n