For independent switching of four loads via make contacts. The actuator has integrated current detection that measures the load current on each channel. All 230 V switch outputs can be operated with manual switches. With integrated bus coupling unit. \n \nFor installation on DIN rails EN 50022. The bus is connected using a bus connecting terminal; a data rail is not necessary. A green LED indicates that the device is ready for operation once the application has been loaded. The load is connected with screw terminals. \n

FEATURES

\n- Operation as break contact or make contact \n- Staircase lighting function with/without manual OFF function and switch off warning \n- Delay functions \n- Scenes \n- Logic function \n- Blocking or priority control \n- Feedback function \n- Status \n- Central function with delay \n- Parameterisation for bus voltage failure and recovery \n- Behaviour for download \n- Current detection function: Behaviour when value exceeds/falls short of the threshold value \n- Energy, operating and switch on counter with limit value monitoring \n- Flash function \n

TECHNICAL DETAILS

\n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n

BUS type:	KNX
Number of contacts:	4
Total number of 18 mm modules:	4
Mounting support:	DIN rail
[Ue] Rated operational voltage:	230 V
Network frequency:	50...60 Hz
[In] Rated current:	0.1...16 A
Load type:	Parallel compensated fluorescent lamp : <= 2500 VA, 230 V AC \nIncandescent lamps : <= 3600 W, 230 V AC \nHalogen lamps : <= 2500 W, 230 V AC \nCapacitive : 16 A - 200 µF, 100...240 V AC \nMotor : <= 1000 W, 230 V AC
IP degree of protection:	IP20

\n