FUNCTION DESCRIPTION:

\n- 6-way heating actuator MIX2 \n- With 6 temperature controllers (P/PI) for heating and cooling \n- Extension module MIX2 \n- For upgrading to maximum of 18 channels \n- For controlling thermal actuators 24 V - 240 V AC in 2 groups with 3 outputs and 450 mA each \n- (Due to the switch-on behaviour of the actuators, we recommend not to exceed a maximum load of 3x1 actuators 24 V AC or 3x5 actuators 230 V AC) \n- Short-circuit-proof and overcharge protected \n- Continuous or switching actuating value selectable \n- Valve protection function can be deactivated \n- With the modes: comfort, standby, night as well as frost/heating protection \n- Changeover to summer mode possible \n- Up to two extension modules MIX or MIX2 can be connected to one base module \n- Device and KNX bus module can be swapped independently of each other \n- Removable KNX bus module enables devices to be changed without reprogramming \n- Manual set-up and use of actuator is possible without KNX bus module \n- LED switching status display for each channel \n- Manual operation on device (even without bus connection) \n

TECHNICAL DETAILS

\n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n

Stand-by consumption	~0.2 W
Width	4 modules
Installation type	DIN rail
Number of channels	6
Type of connection	Screw terminals
Max. cable cross section	Solid wire: 0.5 mm² (Ø 0.8) to 4 mm² | Stranded wire with end sleeve: 0.5 mm² to 2.5 mm²
Switching output	Not potential-free
Output	Triac, 0.45 A
Voltage output	24 V AC - – 240 V AC
Frequency output	50 -– 60 Hz
Suitable for SELV	Yes if all channels switch at SELV
Switching of various phases	Possible
Ambient temperature	-5°C ... 45°C
Type of protection	IP 20
Protection class	II according to EN 60 669

\n