For independent switching of 12 loads via make contacts. All 230 V switch outputs can be operated with manual switches. With integrated bus coupler. \n \nThe device is connected to the mains via screw terminals; every second L connection is bridged internally. For installation on DIN rails EN50022. The bus is connected using a bus connecting terminal; a data rail is not necessary. A green LED indicates readiness for operation after the application has been loaded. \n

FEATURES

\n- Operation as break or make contact \n- Delay functions for each channel \n- Staircase lighting function with/without manual OFF function \n- Cut-out warning for staircase lighting function \n- Blocking and additional logic operation or priority control \n- Scenes - Status feedback function per channel \n- Central function \n- Comprehensive parameterisation for bus voltage failure and recovery \n- Parameterisable download behaviour \n

TECHNICAL DETAILS

\n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n \n

BUS type:	KNX
Number of contacts:	12
Total number of 18 mm modules:	12
Mounting support:	DIN rail
[Ue] Rated operational voltage:	230 V
Network frequency:	50...60 Hz
[In] Rated current:	16 A
Load type:	Fluorescent lamps : <= 2500 VA, 230 V AC \nIncandescent lamps : <= 3600 W, 230 V AC \nHalogen lamps : <= 2500 W, 230 V AC \nCapacitive : 16 A - 200 µF, 230 V AC
IP degree of protection:	IP20

\n